Fitting Instruction

Before anything, check fitment of your graphics against your bike. Every part, if any problems, emails us
BEFORE you go any further. We're fast, so get to it! Email us at info@nitromx.com with all the details of
your order.
If you have any other questions, no matter how silly it may seem, write to us, we're here to help. Seriously!

(1)
Remove old graphics or stickers. Removing old glues or adhesive can be best achieved by using petrol (gas),
ightly applied by brush. It breaks down the chemicals in the glues and will wash away after a few minutes. You
may have to do this a few times to clear it all away. Then get into your usual wash with detergents, - make it
super clean like you never have before. Finally, clean with a grease-free cleaner, then do not touch the
plastic/metal surfaces with your fingers.

(2)
To apply your graphics, we believe it is easier to leave the plastics on the bike as this provides a solid ‘work
bench’. DO NOT SPRAY WATER OR ANYTHING ON THE ADHESIVE SIDE OF THE GRAPHIC! We
recommend starting the fitting of your graphics on a small part of your bike, like swing arms, or fenders, to get a
“feel” of how the graphics go on. First, peel the backing paper back about 10 cm, fold it right back and crease
the paper. Then lay the graphic on the applicable part of your bike and lightly press this into place. Then check
the alignment of the rest of the graphic, looks right? Check mounting holes and vents. Understand that there is a
degree of flex in the graphic and if you do go “off course”, you can pull the graphic back into line, or even apply
gentle heat from a hair dryer.

Once everything looks like it’s in alignment, start pulling the backing paper out from the back side of the graphic.
Gently smooth the graphic on, ensuring you have no bubbles trapped.
Take your time. If you rush this job, it’s going to end up a mess.

(3)
Pay special attention to the edges. These are the first areas where graphics typically fail. Be sure, as best as
you can, not to touch the adhesive side of the graphics. Once the graphic is fully applied, push everything down
firmly. We recommend using a soft cloth rather than your fingers.

(4)
If your kit includes number plate backgrounds - there is no magic trick around the muffler side. It's a matter
of simply taking your time. Use hair dryer heat if you need to. Some models are made with almost impossible
curves, however we test all we make, so they will fit.

(5)
Once all is complete, park your bike. 48 hours is good - more is better. Try to keep the bike in a steady
temperature range - recommended is 20°C (68°F.) to ensure the best results. The adhesives in the graphic need
time to cure. Like paint!

(6)
Go impress your friends, and don't forget to send us some images! We'll put your bike up on our website
gallery, make you famous!

Remember if at any time you damage any parts of your graphics following crashes, just email us with the details,
and images, and we can offer replacement parts, fast.